From: Dave Anderson <anderson@xxxxxxxxxx> Subject: Re: [ANNOUNCE] crash gcore command, version 1.3.0-rc is released Date: Wed, 15 Oct 2014 15:11:44 -0400 > > > ----- Original Message ----- >> >> >> (2014/10/14 22:34), Dave Anderson wrote: >> > >> > Hello Daisuke, >> > >> > Thanks for the update -- I will post my results later. >> > >> > However, I note that you did not make the small ARM64 update >> > that I emailed to you last week: >> > >> > This should be changed: >> > >> > #ifdef ARM64 >> > #define ELF_EXEC_PAGESIZE 4096 >> > >> > to: >> > >> > #ifdef ARM64 >> > #define ELF_EXEC_PAGESIZE PAGESIZE() >> > >> > Please make that change. >> > >> >> I'll merge this in the next rc release. > > OK good -- thanks. > > I have successfully tested this version (with the fix above) on ARM64 > kernels configured with 4K and 64K pages, and also when the gcore module > is built and run on an x86_64 host with an ARM64 target. > Thanks. > Another question: another engineer here at Red Hat has recently > created a crash-gcore-command patch that implements support for PPC64, > both big-endian and little-endian. May we post that patch for inclusion > in version 1.3.0? > Sure. It's no problem to merge PPC64 patche. Please post it. However, as you've understood, I have no PPC64 system. I cannot test PPC64 arch at all. Also, who will maintain the PPC64 code? The engineer? or you'll do it in addition to ARM64? -- Thanks. HATAYAMA, Daisuke -- Crash-utility mailing list Crash-utility@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/crash-utility
