Re: [PATCH v2] ALSA: hda/tas2781: Add speaker id check for ASUS projects

[Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>]

On Fri, Oct 18, 2024 at 03:11:18PM +0800, Baojun Xu wrote:
> Add speaker id check by gpio in ACPI for ASUS projects.
> In other vendors, speaker id was checked by BIOS, and was applied in
> last bit of subsys id, so we can load corresponding firmware binary file
> for its speaker by subsys id.
> But in ASUS project, the firmware binary name will be appended an extra
> number to tell the speakers from different vendors. And this single digit
> come from gpio level of speaker id in BIOS.

...

> +	sub = acpi_get_subsystem_id(ACPI_HANDLE(physdev));
> +	if (IS_ERR(sub)) {
> +		dev_err(p->dev, "Failed to get SUBSYS ID.\n");
> +		goto err;
> +	}
> +	// Speaker id was needed for ASUS projects.
> +	if (strstr(sub, TAS2781_ASUS_ID)) {

strstr() is wrong. You can get 1043 in the middle of the bigger number,
or even text.

> +		ret = devm_acpi_dev_add_driver_gpios(p->dev,
> +			tas2781_speaker_id_gpios);
> +		if (ret) {
> +			dev_err(p->dev, "Unable to add GPIO.\n");

> +			goto err;

No need. If this fails, the below most likely fail as well.

> +		}
> +		p->speaker_id = devm_gpiod_get(p->dev, "speakerid", GPIOD_IN);
> +		if (IS_ERR(p->speaker_id)) {
> +			dev_err(p->dev, "Failed to get Speaker id.\n");
> +			goto err;
> +		}
> +	} else {
> +		p->speaker_id = NULL;
> +	}

...

> +	if (tas_priv->speaker_id != NULL) {
> +		// Speaker id need to be checked for ASUS only.
> +		spk_id = gpiod_get_value(tas_priv->speaker_id);
> +		if (spk_id < 0 || spk_id > 1) {

When "> 1" is possible? Isn't it a dead code?

> +			// Speaker id is not valid, use default.
> +			dev_dbg(tas_priv->dev, "Wrong spk_id = %d\n", spk_id);
> +			spk_id = 0;
> +		}
> +		scnprintf(tas_priv->coef_binaryname,

Why 'c' variant? You do not check the return value anyway. So, what's the point?

> +			  sizeof(tas_priv->coef_binaryname),
> +			  "TAS2XXX%04X%01d.bin",
> +			  lower_16_bits(codec->core.subsystem_id),
> +			  spk_id);
> +	} else {
> +		scnprintf(tas_priv->coef_binaryname,

Ditto.

> +			  sizeof(tas_priv->coef_binaryname),
> +			  "TAS2XXX%04X.bin",
> +			  lower_16_bits(codec->core.subsystem_id));
> +	}

...

> @@ -793,7 +844,6 @@ static int tas2781_hda_i2c_probe(struct i2c_client *clt)
>  	const char *device_name;
>  	int ret;
>  
> -
>  	tas_hda = devm_kzalloc(&clt->dev, sizeof(*tas_hda), GFP_KERNEL);
>  	if (!tas_hda)
>  		return -ENOMEM;

Stray change.

-- 
With Best Regards,
Andy Shevchenko