[PATCH v2 16/16] ASoC: doc: remove .dpcm_playback/capture flags

[Kuninori Morimoto <kuninori.morimoto.gx@xxxxxxxxxxx>]

.dpcm_playback/capture flags are no longer needed. remove it.

Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@xxxxxxxxxxx>
---
 Documentation/sound/soc/dpcm.rst | 14 +++++---------
 1 file changed, 5 insertions(+), 9 deletions(-)

diff --git a/Documentation/sound/soc/dpcm.rst b/Documentation/sound/soc/dpcm.rst
index 2d7ad1d91504..259c39add421 100644
--- a/Documentation/sound/soc/dpcm.rst
+++ b/Documentation/sound/soc/dpcm.rst
@@ -157,16 +157,15 @@ FE DAI links are defined as follows :-
 		.codec_dai_name = "snd-soc-dummy-dai",
 		.dynamic = 1,
 		.trigger = {SND_SOC_DPCM_TRIGGER_POST, SND_SOC_DPCM_TRIGGER_POST},
-		.dpcm_playback = 1,
+		.playback_only,
 	},
 	.....< other FE and BE DAI links here >
   };
 
 This FE DAI link is pretty similar to a regular DAI link except that we also
-set the DAI link to a DPCM FE with the ``dynamic = 1``. The supported FE stream
-directions should also be set with the ``dpcm_playback`` and ``dpcm_capture``
-flags. There is also an option to specify the ordering of the trigger call for
-each FE. This allows the ASoC core to trigger the DSP before or after the other
+set the DAI link to a DPCM FE with the ``dynamic = 1``. There is also an
+option to specify the ordering of the trigger call for each FE.
+This allows the ASoC core to trigger the DSP before or after the other
 components (as some DSPs have strong requirements for the ordering DAI/DSP
 start and stop sequences).
 
@@ -189,15 +188,12 @@ The BE DAIs are configured as follows :-
 		.ignore_pmdown_time = 1,
 		.be_hw_params_fixup = hswult_ssp0_fixup,
 		.ops = &haswell_ops,
-		.dpcm_playback = 1,
-		.dpcm_capture = 1,
 	},
 	.....< other BE DAI links here >
   };
 
 This BE DAI link connects DAI0 to the codec (in this case RT5460 AIF1). It sets
-the ``no_pcm`` flag to mark it has a BE and sets flags for supported stream
-directions using ``dpcm_playback`` and ``dpcm_capture`` above.
+the ``no_pcm`` flag to mark it has a BE.
 
 The BE has also flags set for ignoring suspend and PM down time. This allows
 the BE to work in a hostless mode where the host CPU is not transferring data
-- 
2.25.1