On 21-12-23, 18:15, Pierre-Louis Bossart wrote: > >> I don't mind reverting to a dynamically allocated table populated at > >> boot if that was the consensus. > > > > Most of the kernel users I looked have dynamically allocated table > > populated at boot, also out of many users how many would support BTP.? > > Your older platforms, current qcom dont, so not point is adding for > > everyone... > > All Intel hardware supports BTP/BRA, we just didn't have a compelling > reason to enable it so far. I've seen AMD stating that they also have > BTP/BRA. That's 2/3 of controllers. Not all qcom platforms support this, so this would be enabled selectively for them -- ~Vinod
- References:
- [RFC PATCH 00/16] soundwire/ASoC: speed-up downloads with BTP/BRA protocol
- From: Pierre-Louis Bossart
- [RFC PATCH 09/16] soundwire: crc8: add constant table
- From: Pierre-Louis Bossart
- Re: [RFC PATCH 09/16] soundwire: crc8: add constant table
- From: Vinod Koul
- Re: [RFC PATCH 09/16] soundwire: crc8: add constant table
- From: Pierre-Louis Bossart
- Re: [RFC PATCH 09/16] soundwire: crc8: add constant table
- From: Vinod Koul
- Re: [RFC PATCH 09/16] soundwire: crc8: add constant table
- From: Pierre-Louis Bossart
- [RFC PATCH 00/16] soundwire/ASoC: speed-up downloads with BTP/BRA protocol
- Prev by Date: Re: [RFC PATCH 09/16] soundwire: crc8: add constant table
- Next by Date: Re: [PATCH v2 5/5] ASoC: dt-bindings: Add tas2563 into ti,ta2781.yaml to support dsp mode better
- Previous by thread: Re: [RFC PATCH 09/16] soundwire: crc8: add constant table
- Next by thread: [RFC PATCH 11/16] soundwire: intel_auxdevice: add indirection for BPT open/close/send_async/wait
- Index(es):