On 11/1/22 7:46 AM, Igor Mammedov wrote:
On Mon, 31 Oct 2022 14:48:54 +0000
Daniel P. Berrangé <berrange@xxxxxxxxxx> wrote:
On Mon, Oct 31, 2022 at 04:32:27PM +0200, Edward Haas wrote:
Hi Igor and Laine,
I would like to revive a 2 years old discussion [1] about consistent network
interfaces in the guest.
That discussion mentioned that a guest PCI address may change in two cases:
- The PCI topology changes.
- The machine type changes.
Usually, the machine type is not expected to change, especially if one
wants to allow migrations between nodes.
I would hope to argue this should not be problematic in practice, because
guest images would be made per a specific machine type.
Regarding the PCI topology, I am not sure I understand what changes
need to occur to the domxml for a defined guest PCI address to change.
The only think that I can think of is a scenario where hotplug/unplug is
used,
but even then I would expect existing devices to preserve their PCI address
and the plug/unplug device to have a reserved address managed by the one
acting on it (the management system).
Could you please help clarify in which scenarios the PCI topology can cause
a mess to the naming of interfaces in the guest?
Are there any plans to add the acpi_index support?
This was implemented a year & a half ago
https://libvirt.org/formatdomain.html#network-interfaces
though due to QEMU limitations this only works for the old
i440fx chipset, not Q35 yet.
Q35 should work partially too. In its case acpi-index support
is limited to hotplug enabled root-ports and PCIe-PCI bridges.
One also has to enable ACPI PCI hotplug (it's enled by default
on recent machine types) for it to work (i.e.it's not supported
in native PCIe hotplug mode).
So if mgmt can put nics on root-ports/bridges, then acpi-index
should just work on Q35 as well.
With only a few exceptions (e.g. the first ich9 audio device, which is
placed directly on the root bus at 00:1B.0 because that is where the
ich9 audio device is located on actual Q35 hardware), libvirt will
automatically put all PCI devices (including network interfaces) on a
pcie-root-port.
After seeing reports that "acpi index doesn't work with Q35
machinetypes" I just assumed that was correct and didn't try it. But
after seeing the "should work partially" statement above, I tried it
just now and an <interface> of a Q35 guest that had its PCI address
auto-assigned by libvirt (and so was placed on a pcie-root-port)m and
had <acpi index='4'/> was given the name "eno4". So what exactly is it
that *doesn't* work?
