I've added an interface element to a libvirt network, but it isn't
working. The interface is not being added to the bridge, even after the
system is rebooted.
# virsh net-dumpxml ocp4-net
<network>
<name>ocp4-net</name>
<uuid>b5852945-9889-4d22-ba61-879125316cec</uuid>
<forward dev='eno2' mode='nat'>
<nat>
<port start='1024' end='65535'/>
</nat>
<interface dev='eno2'/>
</forward>
<bridge name='virbr-ocp4' stp='on' delay='0'/>
<mac address='52:54:00:99:99:99'/>
<ip address='192.168.123.1' netmask='255.255.255.0'>
</ip>
</network>
# brctl show
bridge name bridge id STP enabled interfaces
virbr-ocp4 8000.525400999999 yes vnet0
virbr0 8000.525400a7ce7f yes
virbr1 8000.52540051eb1f yes vnet1
# rpm -q libvirt
libvirt-8.0.0-2.module_el8.6.0+1087+b42c8331.x86_64
Any ideas?
--
========================================================================
Google Where SkyNet meets Idiocracy
========================================================================
