On 13.01.2014 16:10, Ivan Gooten wrote: > hi, > > recently i've been busy with libvirt(d) v1.2.0 on armhf and i see, even > if selinux sec driver is enabled on the configure stage, the driver is > not finally created. these configure parameters are: > > --with-selinux > --with-secdriver-selinux > --with-selinux-mount=/sys/fs/selinux > > the /sys/fs/selinux is valid, selinux is running in permissive mode, got > also libselinux DEV package installed, so no missing req. headers here. > > when trying to run libvirtd, i'm getting: > > error : virSecurityDriverLookup:78 : unsupported configuration: Security > driver selinux not enabled > error : lxcSecurityInit:1461 : Failed to initialise security drivers > error : virStateInitialize:854 : Initialisation of LXC state driver > failed: unsupported configuration: Security driver selinux not enabled > error : daemonRunStateInit:909 : Driver state initialisation failed > > someone got any clue what may be causing this? > > thanks, > ivan gooten > Are you sure selinux is enabled? Not enforcing, just enabled. Michal _______________________________________________ libvirt-users mailing list libvirt-users@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvirt-users
