On Wed, Jul 18, 2012 at 11:22:00AM +0100, Morgan Cox wrote: > Hi > > I was under the impression that virt-clone would create new UUId,s etc > where as virt-resize doesn't ? In my previous message I said: "[...] plus it [virt-clone] makes a handful of changes to the libvirt config. You can do most of this by alternate means." > All I am trying to do is use a VM (in LVM) as a template to use to clone . > > The templates are only about 3GB - so to deploy the template I need to > resize them. > > This is why i did this > > TEMPLATE -> [virt-clone] -> new_vm.tmp (to create new UUIDs , etc) If virt-clone doesn't work then you should just copy and resize the disk image using one step of virt-resize, create a new libvirt XML configuration, and finally 'virsh define' the new guest. This would involve just a single copy and is about the most efficient way of doing it (even using qcow2 or LUN clones / FlexClone is unlikely to be better). > If there is a more sensible way of doing this I would like to know ! See above. > Anyway is there a way of forcing being able to copy to an existing LVM > partition ?? As mentioned I could do it fine in Ubuntu 10.04 not > 12.04 - i.e do I need to recompile libvirt, etc ? $ virt-resize /dev/vg/lv_template /dev/vg/lv_new Rich. -- Richard Jones, Virtualization Group, Red Hat http://people.redhat.com/~rjones virt-p2v converts physical machines to virtual machines. Boot with a live CD or over the network (PXE) and turn machines into Xen guests. http://et.redhat.com/~rjones/virt-p2v _______________________________________________ libvirt-users mailing list libvirt-users@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvirt-users
