On Thu, Jun 19, 2014 at 12:51 AM, Eric Blake <eblake@xxxxxxxxxx> wrote: > After years of finger training, I'm so used to 'make check' just > working, that I lose quite a bit of time re-learning that in this > project, it is spelled 'python setup.py build check'. A shim > makefile bridges the gap. > > * Makefile: New file. I see no harm in adding this. Definitely makes a developer's life easier. :) > > Signed-off-by: Eric Blake <eblake@xxxxxxxxxx> > --- > > I'd like to add this to the repo, but even if it gets rejected, > I'll still keep it in my local tree :) > > Makefile | 18 ++++++++++++++++++ > 1 file changed, 18 insertions(+) > create mode 100644 Makefile > > diff --git a/Makefile b/Makefile > new file mode 100644 > index 0000000..6c8da0a > --- /dev/null > +++ b/Makefile > @@ -0,0 +1,18 @@ > +# Shim wrapper around setup.py to allow for familiar build targets > + > +PYTHON ?= python > + > +all: > + $(PYTHON) setup.py build > + > +install: all > + $(PYTHON) setup.py install > + > +clean: > + $(PYTHON) setup.py clean > + > +check: all > + $(PYTHON) setup.py test > + > +rpm: > + $(PYTHON) setup.py rpm > -- > 1.9.3 > > -- > libvir-list mailing list > libvir-list@xxxxxxxxxx > https://www.redhat.com/mailman/listinfo/libvir-list -- Nehal J Wani -- libvir-list mailing list libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list