On Fri, Jan 4, 2013 at 1:44 AM, Doug Goldstein <cardoe@xxxxxxxxxx> wrote: > On Thu, Jan 3, 2013 at 3:44 PM, Zeeshan Ali (Khattak) > <zeeshanak@xxxxxxxxx> wrote: >> Hi, >> I updated my libvirt git clone and install yesterday (after about a >> month or so) and now I can't start domains: >> >> $ virsh start fedora18 >> error: Failed to start domain fedora18 >> error: unsupported configuration: This QEMU does not support QXL >> graphics adapters >> >> While libvirt is self-built, I'm using qemu 1.2.2-1.fc18 from vanila >> Fedora 18 repo. Just to be clear, qemu was not updated before the >> problem appeared, only libvirt. >> >> Here is the libvirtd log: >> http://static.fi/~zeenix/tmp/libvirtd-session-zeenix.log (13 MB). >> >> Also attaching the domain config. >> >> -- >> Regards, >> >> Zeeshan Ali (Khattak) >> FSF member#5124 >> > > Try the patch I sent in response to your original message. Not sure if > that's the 100% fix we want. Need to check if we should also be > checking for SPICE support in qemu_command.c but it should at the very > least get you going for now. Thanks, I'll try that. -- Regards, Zeeshan Ali (Khattak) FSF member#5124 -- libvir-list mailing list libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list