A few examples for <interface> had a type='direct' interface with no sub-elements. This is not allowed - a type='direct' interface must have at least a source element. (Most likely the example was copied from the type='user' or type='ethernet' examples - they *do* allow an instance with no sub-elements). There was also one place that mistakenly used %lt; ... %gt; instead of < ... > (for some reason, I make that typo all the time). --- Pushed under the trivial rule. docs/formatdomain.html.in | 5 +---- 1 file changed, 1 insertion(+), 4 deletions(-) diff --git a/docs/formatdomain.html.in b/docs/formatdomain.html.in index 95c3edc..b2e5db9 100644 --- a/docs/formatdomain.html.in +++ b/docs/formatdomain.html.in @@ -2364,7 +2364,6 @@ <pre> ... <devices> - <interface type='direct'/> ... <interface type='direct'> <source dev='eth0' mode='vepa'/> @@ -2413,7 +2412,6 @@ <pre> ... <devices> - <interface type='direct'/> ... <interface type='direct'> <source dev='eth0.2' mode='vepa'/> @@ -2441,7 +2439,6 @@ <pre> ... <devices> - <interface type='direct'/> ... <interface type='direct'> <source dev='eth0' mode='private'/> @@ -2462,7 +2459,7 @@ passthrough, after first optionally setting the device's MAC address to the configured value, and associating the device with an 802.1Qgh capable switch using an optionally specified - %lt;virtualport%gt; element (see the examples of virtualport + <virtualport> element (see the examples of virtualport given above for type='direct' network devices). Note that - due to limitations in standard single-port PCI ethernet card driver design - only SR-IOV (Single Root I/O Virtualization) virtual -- 1.7.10.2 -- libvir-list mailing list libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list