On 05/31/2012 08:33 AM, Onkar wrote: > Hello All, > Any idea on this issue ? > > Regards, > Onkar > > -------- Forwarded Message -------- > From: Onkar <kernzap@xxxxxxxxx> > To: libvir-list <libvir-list@xxxxxxxxxx> > Subject: error: this function is not supported by the connection > driver : virConnectNumOfStoragePool > Date: Wed, 30 May 2012 21:29:42 +0530 > > Hello, > > I configured libvirt like this > ./configure --prefix=/ --exec-prefix=/usr/ --libdir=/usr/lib64/ > --with-storage-dir --with-storage-dir --with-storage-dir > --with-storage-dir --with-storage-dir --with-storage-dir > --with-storage-dir --with-storage-dir --with-qemu --with-libvirtd > --with-selinux --with-network --with-libblkid > > and then, > > make -j4 > make install > > and then > > # virsh list --all > Id Name State > ---------------------------------------------------- > - vm1 shut off > > # virsh pool-list --all > error: Failed to list active pools > error: this function is not supported by the connection driver: > virConnectNumOfStoragePools > > > getting this error , any clues on why is this error ? > > > Regards, > Onkar > Hi, I'm not saying it is the case, but it could've happened: If you installed from git and your pool resides in ~/.libvirt, then it is possible, that thisthis was moved to ~/.config/libvirt and storage driver failed to start. If you are building with modules enabled, then the module didn't get to load (and unfortunately didn't show any message, this should be a bug) and you have no storageDriver available, that's why you see this message. This is what happened to me. The solution is to virsh pool-edit the pool after you configured and installed with --without-driver-modules. Martin -- libvir-list mailing list libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list