On 20/01/2011, at 9:26 PM, Marcela Castro León wrote: Hello > > I've finished the installation. The daemon is not up, so I've tried in that way: > > chubut@chubut:/usr/local/sbin$ sudo ./libvirtd start start > 11:23:17.543: 6168: warning : networkAddGeneralIptablesRules:1097 : Could not add rule to fixup DHCP response checksums on network 'default'. > 11:23:17.543: 6168: warning : networkAddGeneralIptablesRules:1098 : May need to update iptables package & kernel to support CHECKSUM rule. > 11:23:17.577: 6168: warning : qemudStartup:1331 : Unable to create cgroup for driver: No such device or address > 11:23:17.704: 6168: warning : lxcStartup:2128 : Unable to create cgroup for driver: No such device or address > > And stay there, doesn't finish, and not start. > > Can you tell me if i'm doing in the right way? Hi Marcela, When you start the libvirt daemon from the command line, it keeps in the foreground, without going back to a shell prompt. ie: $ sudo./libvirtd (various messages print out here, but libvirtd doesn't exit) Since the libvirt daemon has effectively taken over that terminal session, if I start another terminal session, I can generally use virsh to connect to it. Have you tried that? Starting a new terminal session while libvirtd is running, and then using virsh or virt-manager or something. ? Regards and best wishes, Justin Clift -- libvir-list mailing list libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list