On 13/01/2011, at 9:06 AM, Justin Clift wrote: > On 13/01/2011, at 8:54 AM, Eric Blake wrote: >> On 01/12/2011 02:24 PM, Justin Clift wrote: >>> Addresses BZ # 622534: >>> >>> https://bugzilla.redhat.com/show_bug.cgi?id=622534 >>> --- >>> tools/virsh.pod | 28 ++++++++++++++++++---------- >>> 1 files changed, 18 insertions(+), 10 deletions(-) >>> >>> diff --git a/tools/virsh.pod b/tools/virsh.pod >>> index 0e03d68..b4c6ff7 100644 >>> --- a/tools/virsh.pod >>> +++ b/tools/virsh.pod How's this for new virsh text for the setvcpus bit? setvcpus domain-id count optional --maximum --config --live Change the number of virtual CPUs active in a guest domain. By default, this command works on active guest domains. To change the settings for an inactive guest domain, use the --config flag. The count value may be limited by host, hypervisor, or a limit coming from the original description of the guest domain. For Xen, you can only adjust the virtual CPUs of a running domain if the domain is paravirtualized. If the --config flag is specified, the change is made to the stored XML configuration for the guest domain, and will only take effect when the guest domain is next started. If --live is specified, the domain must be active, and the change takes place immediately. Both the --config and --live flags may be specified together if supported by the hypervisor. When neither the --config nor --live flags are given, the --live flag is assumed and the guest domain must be active. In this situation it is up to the hypervisor whether the --config flag is also assumed, and therefore whether the XML configuration is adjusted to make the change persistent. The --maximum flag controls the maximum number of virtual cpus that can be hot-plugged the next time the domain is booted. As such, it must only be used with the --config flag, and not with the --live option. + Justin -- libvir-list mailing list libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list