On 11/01/2010 08:50 PM, Zdenek Styblik wrote: > On 11/01/10 20:18, Diego Elio Pettenà wrote: >> Il giorno lun, 01/11/2010 alle 19.45 +0100, Zdenek Styblik ha scritto: >>> I'm using virt-managers to add/attach devices. I've failed to attach >>> PCI >>> device, but it "does not" matter right now. I can attach USB devices, >>> but they are not in VM. I've tried to attach USB HUB as well and what >>> not - nothing. >> >> I'd suggest you to try with the current git head. I had had some trouble >> with this the past week or so: >> > > Ok, I'm going to try it tomorrow. > >> - 0.8.5 release will not allow access to the device if cgroups are >> enabled. >> > > I've commented cgroups out in qemu.conf and - it didn't help. :| > >> Not sure about the PCI stuff sincerely, but at least USB with the >> current git head works fine for me (finally). >> > > Zdenek > Well, tested with your patch and - it works only half-way, or I'm doing something wrong(I'm sure I do, but I don't know what). I can see device(s) in % lsusb; in guest, however eg. USB flash disk can be seen, but - that's all. Like it doesn't exist. It's just not there. I've tried to comment in/out cgroups and it doesn't matter. What I'm getting is: "usb X: reset full speed USB device using uhci_hcd and address Y" That can't be good :) Damn, this is harder than I thought. Thanks, Zdenek -- Zdenek Styblik Net/Linux admin OS TurnovFree.net email: stybla@xxxxxxxxxxxxxx jabber: stybla@xxxxxxxxxxxxxxxxxxxxx -- libvir-list mailing list libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list