On 10/29/2010 01:35 AM, Eric Blake wrote: > ACK - both descriptions look okay to me. But before you push, be sure > virsh.pod also has similar wording. Thanks, pushed. :) Good point about the .pod file too. Adjusted the descriptions in there as follows: For managedsave Save and destroy a running domain, so it can be restarted from the same state at a later time. When the virsh start command is next run for the domain, it will automatically be started from this saved state. For managedsave-remove Remove the managedsave state file for a domain, if it exists. This ensures the domain will do a full boot the next time it is started. For start Start a (previously defined) inactive domain, either from the last managedsave state, or via a fresh boot if no managedsave state is present. The domain will be paused if the --paused option is used and supported by the driver; otherwise it will be running. If --console is requested, attach to the console after creation. -- libvir-list mailing list libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list