On Mon, May 10, 2010 at 09:34:11PM +0800, Osier Yang wrote: > Hello there > with newest libvirt, when I connect to the container via > console, then execute "ifconfig", there will be no output, though > the network works fine. and "/proc/net/dev" of container seems good > too. (has entries about "eth0" and "lo"). I traced the call > procedure of "ifconfig", it reads the infomations of network > interface from "/proc/net/dev" and vise visa. so I'm confused about > what cause this problem. > > there is no problem with libvirt-0.8.0-4. That's rather strange, as I don't spot any lxc specific patch being applied between libvirt-0.8.0 and 0.8.1 . Are you sure you were using the same kernel for both tests ? Daniel -- Daniel Veillard | libxml Gnome XML XSLT toolkit http://xmlsoft.org/ daniel@xxxxxxxxxxxx | Rpmfind RPM search engine http://rpmfind.net/ http://veillard.com/ | virtualization library http://libvirt.org/ -- libvir-list mailing list libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list