Trivially replace usages of qemu and lxc in the virsh manpage with their more heavily used and (according to Wikipedia) correct upper-case spellings QEMU and LXC. Signed-off-by: Michael Weiser <michael.weiser@xxxxxx> Suggested-by: Daniel Henrique Barboza <danielhb413@xxxxxxxxx> --- docs/manpages/virsh.rst | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-) diff --git a/docs/manpages/virsh.rst b/docs/manpages/virsh.rst index fea0527caf..7e26676570 100644 --- a/docs/manpages/virsh.rst +++ b/docs/manpages/virsh.rst @@ -577,7 +577,7 @@ from the domain's XML <os/> element and <type/> subelement or one from a list of machines from the ``virsh capabilities`` output for a specific architecture and domain type. -For the qemu hypervisor, a *virttype* of either 'qemu' or 'kvm' must be +For the QEMU hypervisor, a *virttype* of either 'qemu' or 'kvm' must be supplied along with either the *emulatorbin* or *arch* in order to generate output for the default *machine*. Supplying a *machine* value will generate output for the specific machine. @@ -1072,7 +1072,7 @@ read I/O operations limit. write I/O operations limit. *--size-iops-sec* specifies size I/O operations limit per second. *--group-name* specifies group name to share I/O quota between multiple drives. -For a qemu domain, if no name is provided, then the default is to have a single +For a QEMU domain, if no name is provided, then the default is to have a single group for each *device*. Older versions of virsh only accepted these options with underscore @@ -1084,7 +1084,7 @@ An explicit 0 also clears any limit. A non-zero value for a given total cannot be mixed with non-zero values for read or write. It is up to the hypervisor to determine how to handle the length values. -For the qemu hypervisor, if an I/O limit value or maximum value is set, +For the QEMU hypervisor, if an I/O limit value or maximum value is set, then the default value of 1 second will be displayed. Supplying a 0 will reset the value back to the default. @@ -1642,7 +1642,7 @@ domblkstat Get device block stats for a running domain. A *block-device* corresponds to a unique target name (<target dev='name'/>) or source file (<source file='name'/>) for one of the disk devices attached to *domain* (see -also ``domblklist`` for listing these names). On a lxc or qemu domain, +also ``domblklist`` for listing these names). On a LXC or QEMU domain, omitting the *block-device* yields device block stats summarily for the entire domain. @@ -3247,7 +3247,7 @@ destination). Some hypervisors do not support this feature and will return an error if this parameter is used. Optional *disks-port* sets the port that hypervisor on destination side should -bind to for incoming disks traffic. Currently it is supported only by qemu. +bind to for incoming disks traffic. Currently it is supported only by QEMU. migrate-compcache -- 2.24.1 -- libvir-list mailing list libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list
