On Tue, Jul 30, 2019 at 04:01:15PM +0200, Andrea Bolognani wrote: > On Mon, 2019-07-29 at 18:11 +0100, Daniel P. Berrangé wrote: > [...] > > +virtsecretd.service: secret/virtsecretd.service.in $(top_builddir)/config.status > > + $(AM_V_GEN)sed $(VIRTSECRETD_UNIT_VARS) < $< > $@-t && mv $@-t $@ > > + > > +virtsecret%.socket: remote/libvirt%.socket.in $(top_builddir)/config.status > > + $(AM_V_GEN)sed $(VIRTSECRETD_UNIT_VARS) < $< > $@-t && mv $@-t $@ > > + > > +secret/virtsecretd.conf: remote/libvirtd.conf.in > > + $(AM_V_GEN)sed \ > > + -e '/[@]CUT_ENABLE_IP[@]/,/[@]END[@]/d' \ > > + -e 's/[@]DAEMON_NAME[@]/virtsecretd/' \ > > + < $^ > $@ > > Oh, you didn't replace $^ with $< here! I did the previous patch, forgetting i replicated the problem in every following patch. Regards, Daniel -- |: https://berrange.com -o- https://www.flickr.com/photos/dberrange :| |: https://libvirt.org -o- https://fstop138.berrange.com :| |: https://entangle-photo.org -o- https://www.instagram.com/dberrange :| -- libvir-list mailing list libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list
