Hi Cédric,
I have tested it, it works well. But the interface name will repeat 2 times. Please help to confirm this, and if below test for a single port host is enough?
# cat /proc/sys/net/ipv6/conf/enp0s25/accept_ra
1
enable network default with ipv6 ip section
# virsh net-start default
error: Failed to start network default
error: internal error: Check the host setup: enabling IPv6 forwarding with RA routes without accept_ra set to 2 is likely to cause routes loss. Interfaces to look at: enp0s25, enp0s25
# echo 2 > /proc/sys/net/ipv6/conf/enp0s25/accept_ra
# virsh net-start default
Network default started
# virsh net-create default.xml
error: Failed to create network from default.xml
error: internal error: Check the host setup: enabling IPv6 forwarding with RA routes without accept_ra set to 2 is likely to cause routes loss. Interfaces to look at: enp0s25, enp0s25
On Wed, Mar 15, 2017 at 10:45 PM, Cédric Bosdonnat <cbosdonnat@xxxxxxxx> wrote:
Hi Laine, all,
Here is the v2 of my series. The changes are:
* Add a commit to create a virNetDevGetName() function
* Fix Laine's comments
Cédric Bosdonnat (5):
util: extract the request sending code from virNetlinkCommand()
util: add virNetlinkDumpCommand()
bridge_driver.c: more uses of SYSCTL_PATH
util: add virNetDevGetName() function
network: check accept_ra before enabling ipv6 forwarding
src/libvirt_private.syms | 3 +
src/network/bridge_driver.c | 25 ++++---
src/util/virnetdev.c | 19 ++++++
src/util/virnetdev.h | 2 +
src/util/virnetdevip.c | 158 ++++++++++++++++++++++++++++++++++++++++++++
src/util/virnetdevip.h | 1 +
src/util/virnetlink.c | 145 ++++++++++++++++++++++++++++++----------
src/util/virnetlink.h | 9 +++
8 files changed, 319 insertions(+), 43 deletions(-)
--
2.11.0
--
libvir-list mailing list
libvir-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/libvir-list
--
Best Regards,
Yalan Zhang-- libvir-list mailing list libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list
