Hey, i am running an unusual setup where i assign pci devices behind the back of libvirt. I have two options to do that: 1. a wrapper script for qemu that takes care of suid-root and appends arguments for pci-assign 2. virsh qemu-monitor-command ... 'device_add pci-assign...' I know i should probably not be doing this, it is a workaround to introduce fine-grained pci-assignment in an openstack setup, where vendor and device id are not enough to pick the right device for a vm. In both cases qemu will crash with the following output: > qemu: hardware error: pci read failed, ret = 0 errno = 22 followed by the usual machine state dump. With strace i found it to be a failing read on the config space file of my device. /sys/bus/pci/devices/0000:xx:xx.x/config A few reads out of that file succeeded, as well as accesses on vendor etc. Manually launching a qemu with the pci-assign works without a problem, so i "blame" libvirt and the cgroup environment the qemu ends up in. So i put a bash into the exact same cgroup setup - next to a running qemu, expecting a dd or hexdump on the config-space file to fail. But from that bash i can read the file without a problem. Has anyone seen that problem before? Right now i do not know what i am missing, maybe qemu is hitting some limits configured for the cgroups or whatever. I can not use pci-assign from libvirt, but if i did would it configure cgroups in a different way or relax some limits? What would be a good next step to debug that? Right now i am looking at kernel event traces, but the machine is pretty big and so is the trace. That assignment used to work and i do not know how it broke, i have tried combinations of several kernels, versions of libvirt and qemu. (kernel 3.18 and 4.4, libvirt 1.3.2 and 2.0.0, and qemu 2.2.1 and 2.7) All combinations show the same problem, even the ones that work on other machines. So when it comes to software versions the problem could well be caused by a software update of another component, that i got with the package manager and did not compile myself. It is a debian 8.6 with all recent updates installed. My guess would be that systemd could have an influence on cgroups or limits causing such a problem. regards, Henning -- libvir-list mailing list libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list