Zvi Dubitzky wrote: > Using libvirt virDomainMigrate () do I have to set the target VM with > same XML config as the source VM machine before the > migrate starts or the source machine Host libvirt takes care of this > preparation before it starts the live migration. > > I am talking about the equivalent of a tcp migration as defined per the > qemu/kvm migrate command done via the qemu monitor This is taken care of by the migration protocol. Essentially what happens is that you run a command like: # virsh migrate --live guest qemu+tls://dest.example.org/system And in the background, virsh connects to both the local, "source" machine, and the remote "destination" machine. It then transfers the XML from the source to the dest, starts up the "container" on the dest with the -incoming command-line arg, and then does the migration. The short of it is that yes, libvirt takes care of all of this behind the scenes. -- Chris Lalancette -- Libvir-list mailing list Libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list