Hello,
I would like to set a specify default gateway for my VMs. However I’m not succeeding
Here after is the isolated lan, where I added the statement <route address='10.0.0.0' prefix='8' gateway='10.10.0.7’/> where my aim is to route to the 10.10.0.7
What should I do , to make it works ?
Thanks
<network>
<name>prd-private-lan</name>
<uuid>255083f4-05a1-4a24-bc66-d3a3a9ab0724</uuid>
<bridge name='virbr3' stp='off' delay='0'/>
<mac address='52:54:00:08:1e:d8'/>
<domain name='prd.pipiche.net'/>
<dns>
<forwarder addr='8.8.4.4'/>
<forwarder addr='8.8.8.8'/>
</dns>
<ip address='10.10.0.1' netmask='255.255.255.0'>
<dhcp>
<range start='10.10.0.128' end='10.10.0.254'/>
<host mac='52:54:10:b6:35:ca' ip='10.10.0.3'/>
<host mac='52:54:10:5f:92:05' ip='10.10.0.7'/>
<host mac='52:54:10:7d:3a:3f' ip='10.10.0.10'/>
<host mac='52:54:10:30:93:56' ip='10.10.0.21'/>
<host mac='52:54:10:78:c1:c2' ip='10.10.0.22'/>
<host mac='52:54:10:64:00:21' ip='10.10.0.25'/>
<host mac='52:54:10:5a:5f:63' ip='10.10.0.26'/>
<host mac='52:54:10:4c:b2:61' ip='10.10.0.27'/>
<host mac='52:54:10:62:de:5f' ' ip='10.10.0.62'/>
</dhcp>
</ip>
<route address='10.0.0.0' prefix='8' gateway='10.10.0.7'/>
</network>
When looking on the VM (guest) the route is not correctly set
route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
10.10.0.0 0.0.0.0 255.255.255.0 U 100 0 0 ens4
arp -a
? (10.10.0.1) at 52:54:00:08:1e:d8 [ether] on ensue
ifconfig
ens4: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 10.10.0.27 netmask 255.255.255.0 broadcast 10.10.0.255
inet6 fe80::5054:10ff:fe4c:b261 prefixlen 64 scopeid 0x20<link>
ether 52:54:10:4c:b2:61 txqueuelen 1000 (Ethernet)
RX packets 1805 bytes 153644 (150.0 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 1745 bytes 136075 (132.8 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
--
libvir-list mailing list
libvir-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/libvir-list