Am 22.02.2009 um 17:25 schrieb Andreas Rittershofer:
I want to setup networking under KVM and with libvirt. I read a lot
the last two days, but it is not working as desired. I don't want
bridging, I want it with a tap-device created via vde_switch. I
cannot figure out what to put in /etc/libvirt/qemu/machine.xml and /
etc/libvirt/qemu/networks/network.xml - there is no really good
documentation. /var/log/libvirt/qemu/maschine.log shows a lot of
parameters when I start the VM with virsh start machine, but I
cannot figure out where to set these values or where to set the
defaults.
Now the network is running - but:
1.) I don't know why.
2.) It runs only one or two minutes and than dies. I have to reboot
the virtual machine to get it up and running again - and I don't no
why either.
mfg ar
--
Hier könnte keine Signatur stehen.
--
Libvir-list mailing list
Libvir-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/libvir-list