On 16.04.2015 21:42, Cole Robinson wrote: > If libvirt-daemon-config-network is installed while libvirtd is already > running, the daemon needs to be restarted to pick up the change. > > Instead let's trigger a daemon reload when the package is first installed. > Then the default network is available immediately if libvirtd was already > running. > > https://bugzilla.redhat.com/show_bug.cgi?id=867546 > --- > libvirt.spec.in | 8 ++++++++ > 1 file changed, 8 insertions(+) > > diff --git a/libvirt.spec.in b/libvirt.spec.in > index e08c9e7..ada0257 100644 > --- a/libvirt.spec.in > +++ b/libvirt.spec.in > @@ -1770,6 +1770,14 @@ if test $1 -eq 1 && test ! -f %{_sysconfdir}/libvirt/qemu/networks/default.xml ; > < %{_datadir}/libvirt/networks/default.xml \ > > %{_sysconfdir}/libvirt/qemu/networks/default.xml > ln -s ../default.xml %{_sysconfdir}/libvirt/qemu/networks/autostart/default.xml > + > + # Make sure libvirt picks up the new network defininiton > + %if %{with_systemd} > + /bin/systemctl reload libvirtd.service >/dev/null 2>&1 ||: > + %else > + /sbin/service libvirtd reload > /dev/null 2>&1 || : > + %endif > + > fi > %endif > > There's already a 'systemctl try-restart libvirtd.service' call just a few lines below. They were added in 4789fb2e. I think we can use them - also, I'm not sure why it doesn't work since we are restarting daemon even now (without this patch). Michal -- libvir-list mailing list libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list