On Mon, Sep 08, 2014 at 13:21:52 +0200, Peter Krempa wrote: > On 09/08/14 13:05, Jiri Denemark wrote: > > When QEMU fails during incoming migration after we successfully started > > it (i.e., during Perform or Finish phase), we report a rather unhelpful > > message > > > > Unable to read from monitor: Connection reset by peer > > > > We already have a code that takes error messages from QEMU's error > > output but we disable it once QEMU successfully starts. This patch > > postpones this until the end of Finish phase during incoming migration > > so that we can report a much better error message: > > > > internal error: early end of file from monitor: possible problem: > > Unknown savevm section or instance '0000:00:05.0/virtio-balloon' 0 > > load of migration failed > > > > https://bugzilla.redhat.com/show_bug.cgi?id=1090093 > > > > Signed-off-by: Jiri Denemark <jdenemar@xxxxxxxxxx> > > --- > > src/qemu/qemu_migration.c | 2 ++ > > src/qemu/qemu_monitor.c | 7 ++++++- > > src/qemu/qemu_process.c | 6 ++++-- > > 3 files changed, 12 insertions(+), 3 deletions(-) > > ACK, although you could state that this is done with migrations now too > in the comment above the code that parses the monitor error message. I did so and pushed the patch. Thanks. Jirka -- libvir-list mailing list libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list