On Wed, Aug 20, 2008 at 08:01:42PM +0900, Jun Koi wrote: > On Wed, Aug 20, 2008 at 4:30 PM, Jun Koi <junkoi2004@xxxxxxxxx> wrote: > > Hi, > > > > I added some new code to libvirt.c, and recompile. However, when "make > > install". qemud/.libs/libvirtd is installed but not qemud/libvirtd. > > Why? Looks like a bug? No, this is correct behaviour. qemud/libvirtd is not a binary - it is a mere shell script which calls into qemud/.libs/libvirtd. This is all part of the libtool build process. > > The problem is that qemud/libvirtd has my new code, but not > > qemud/.libs/libvirtd! So "make install" installs the old binary, which > > I dont know where it is from. (Perhaps from the first compilation?) You are mistaken - qemud/libvirtd is just a shell script wrapper. The actual binaries are in the .libs directory. > > I am not familiar with the autoconf Makefile, and cannot figure it out > > why it is working this way. > > > > This is not getting funny anymore. I clean src/.libs/*, and > qemud/.libs/*, and recompile and "make install" again. This step > installed stuffs in .libs/ into system. Run 'make distclean' and then start again from 'configure' Daniel -- |: Red Hat, Engineering, London -o- http://people.redhat.com/berrange/ :| |: http://libvirt.org -o- http://virt-manager.org -o- http://ovirt.org :| |: http://autobuild.org -o- http://search.cpan.org/~danberr/ :| |: GnuPG: 7D3B9505 -o- F3C9 553F A1DA 4AC2 5648 23C1 B3DF F742 7D3B 9505 :| -- Libvir-list mailing list Libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list