On Tue, Jan 22, 2008 at 08:27:58AM -0500, Daniel Veillard wrote: > On Tue, Jan 22, 2008 at 08:00:34AM -0500, Daniel Veillard wrote: > > On Mon, Jan 21, 2008 at 11:39:35PM +0000, Daniel P. Berrange wrote: > > > I would point you at the snapshot tar.gz here, but it appears to be not > > > updated since September > > > > > > http://libvirt.org/downloads.html > > > > ./configure: line 35987: syntax error near unexpected token `libxml-2.0,LIBXML_FOUND=yes' > > ./configure: line 35987: ` PKG_CHECK_EXISTS(libxml-2.0,LIBXML_FOUND=yes)' > > > > libvirt.org is a RHEL4 box, seems the pkgconfig requirements which were > > introduced break running autogen.sh , so no Makefile, make dist, and no > > snapshot apparently. I will try to investigate but I can't believe we managed > > to break detection for something as common as libxml2 *on xmlsoft.org itself*, > > the irony ... > > Upgrading pkg-config on the box this goes further but then gets stuck > at: > > configure: error: conditional "HAVE_SASL" was never defined. > Usually this means the macro was only invoked conditionally. > > trying to autogen with > ./autogen.sh --prefix=/usr --without-depends --without-sasl > > I don't understand the problem, it seems > AM_CONDITIONAL(HAVE_SASL, [test "$with_sasl" != "no"]) > is set outside of any conditional block in configure.in > And if I don't specify --without-sasl it breaks when looking > for the library. > > I really don't see how to fix the dist snapshot build on RHEL4 Ok, I'll fire up a RHEL4 guest and figure out the neccessary m4 craziness we need to fix this. The SASL stuff should really auto-enable/disable itself like all the other libs can. Regards, Dan. -- |=- Red Hat, Engineering, Emerging Technologies, Boston. +1 978 392 2496 -=| |=- Perl modules: http://search.cpan.org/~danberr/ -=| |=- Projects: http://freshmeat.net/~danielpb/ -=| |=- GnuPG: 7D3B9505 F3C9 553F A1DA 4AC2 5648 23C1 B3DF F742 7D3B 9505 -=| -- Libvir-list mailing list Libvir-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/libvir-list