Hello,
I had similar problem with RHEL7 recently and it was caused by network. I configured wrong NIC during installation and it dropped to dracut shell.
Regards,
FK
On Thu, Apr 14, 2016 at 9:20 PM, therbur <fxb7-ox9n@xxxxxxxxxxxxxxx> wrote:
therbur <fxb7-ox9n@xxxxxxxxxxxxxxx> wrote:
>I have a Cobbler setup that loads a CentOS 5.7 OK. I am trying to add a
>CentOS 7.2 load.
>
>It stops just after the line that shows:
>
>... dracut-initqueue ... Dload Upload Total Spent Left Speed
>
>Actually, it doesn't stop, it just pauses a long time, then says dozens of
>messages like:
>
>... warning: dracut-initqueue timeout - starting timeout scripts
>
>Then it comes to a "dracut>" prompt. Doing "journalctl" as it suggests, I
>don't see anything obvious that would tell me the actual problem. Also
>tried "cat /proc/cmdline" and it worked, didn't see anything unusual.
>
>What is it looking for when it gets to the dracut-initqueue line? What
>are some possible causes/solutions?
No ideas? In case it's helpful, here's the dracut rdsosreport.txt for the
problem:
http://pastebin.com/uyx8p9bA
_______________________________________________
Kickstart-list mailing list
Kickstart-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/kickstart-list
_______________________________________________ Kickstart-list mailing list Kickstart-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/kickstart-list
