Hi LG,
You might be able to setup the ethernet devices via a bootparam.
Check out the man page for bootparam and search for Ethernet Devices
"man 7 bootparam"
HTH,
Harry
Linux Geek wrote:
Hello,
I am trying to install RHEL5.3 on a system with multiple Network
interfaces. While installation the network device names are not read in
correct/expected order. I set the ksdevice as eth0 ( using ksdevice=eth0
at boot prompt ) however the installer tries to acquire IP for eth2
device. I have tried using "pci=bfsort" with now luck which I believe is
due its applicability on few systems.
Disabling devices in BIOS din't help either.
Is there any way to get this wroking ?
Thanks.
------------------------------------------------------------------------
_______________________________________________
Kickstart-list mailing list
Kickstart-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/kickstart-list
_______________________________________________
Kickstart-list mailing list
Kickstart-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/kickstart-list
