What version of RHEL did you use? I run RHEL4.4 on HP DL series machines which have the same nic and it works just fine. CentOS 4.4 corrosponds to RHEL4.4 so if you tried an earlier release of RHEL then that might explain it. Be aware that the bnx2 driver shipping with RHEL4.4 has a nasty (but rarely seen) bug which took our cluster nodes down every few hours. Something the dlm was doing triggered it. Corey Kovacs Senior Systems Engineer Technology Management Associates 703.279.6168 (B) 855-6168 (R) -----Original Message----- From: kickstart-list-bounces@xxxxxxxxxx [mailto:kickstart-list-bounces@xxxxxxxxxx] On Behalf Of Bill-S Sent: Wednesday, March 14, 2007 1:06 AM To: Kickstart Subject: Adding Broadcom BCM5708 (nic) module to kickstart? Hello Family, I was curious as to how to add a newer nic driver to a pre-exisiting kickstart setup. Broadcom Corporation NetXtreme II BCM5708 Gigabit Ethernet (rev 11) With RHEL4 and the new DELL-2950's, it appears that there is no support for the following network card. I ran CentOS-4.4 "live" and got the following info for the nic came up then: ############################# /etc/modprobe.conf ############################# alias eth1 bnx2 alias eth0 bnx2 alias scsi_hostadapter megaraid_sas alias usb-controller ehci-hcd alias usb-controller1 uhci-hcd ############################# [root@localhost ~]# grep bnx2 /lib/modules/2.6.9-42.livecd.c4/modules.dep /lib/modules/2.6.9-42.livecd.c4/kernel/drivers/net/bnx2.ko: ############################ TIA _______________________________________________ Kickstart-list mailing list Kickstart-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/kickstart-list
