ethtool eth0
This will give you output that looks like this:
Settings for eth0:
Supported ports: [ MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Half
Port: Twisted Pair
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: g
Wake-on: d
Current message level: 0x000000ff (255)
Link detected: yes
-----Original Message-----
From: kickstart-list-bounces@xxxxxxxxxx
[mailto:kickstart-list-bounces@xxxxxxxxxx] On Behalf Of
Elizabeth.Brosch@xxxxxxxxxxx
Sent: Friday, October 07, 2005 2:53 PM
To: kickstart-list@xxxxxxxxxx
Subject: RE: Kickstart fails
Chip - what command do I use to see what the NIC is configured at?
_______________________________________________
Kickstart-list mailing list
Kickstart-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/kickstart-list
