I'll try that later, but, just for reference, which interface does the
ip=x.x.x.x paramter apply to? Can I specify which one? I can DHCP eth0
just fine. It's eth1 that I either need to set statically or disable
entirely.
Lloyd
EXT / HELICE RIVERA Cedric wrote:
Hi,
Maybe you can try this :
linux ks=nfs:nfs_server:/path/to/ ksdevice=eth0 ip=x.x.x.x
If your kickstart config file is complete and it's name is :
"/path/to/ks/x.x.x.x-kickstart"
then the installation will be completely non-interactive, unless the disk
partition table is clean ...
I hope this helps.
++
-----Message d'origine-----
De : kickstart-list-bounces@xxxxxxxxxx
[mailto:kickstart-list-bounces@xxxxxxxxxx]De la part de Lloyd T Brown
Envoyé : jeudi 25 août 2005 16:23
À : kickstart-list@xxxxxxxxxx
Objet : disabling dhcp for eth1 in kernel
Hey all.
Admittedly, I'm new to this whole kickstart thing, but I can't seem to
find an answer to my question anywhere else. For reasons that are out
of my control, I can't provide a DHCP address to the eth1 interface on
the node I'm trying to install. I don't need the eth1 interface to
perform the installation, so I'd like disable it using a kernel
parameter so that the step of configuring the eth1 interface during
kickstart (before it retrieves the ks.cfg over the network) is
non-interactive. This is the last thing I need to do to make my
configuration fully non-interactive and fully remote. Essentially I
need something like this, although I'm making up the parameters:
linux ks=nfs:nfs_server:/path/to/ks.cfg ksdevice=eth0 disable_eth1
Alternatively if someone has a way to specify a static address as a
kernel parameter, that'd be okay too.
Anyone have any ideas?
Thanks,
Lloyd Brown
_______________________________________________
Kickstart-list mailing list
Kickstart-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/kickstart-list
_______________________________________________
Kickstart-list mailing list
Kickstart-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/kickstart-list
