Ethernet Card:
eth0: Tigon3 [partno(BCM95703A30) rev 1002 PHY(5703)]
(PCIX:133MHz:64-bit) 10/100/1000BaseT
Problem: Installing from PXE fails to aquire DHCP address as Kickstart
begins.
Summary:
PXE-Booting aquires DHCP w/ MAC matching
Kernel is passed over and Boots
Kickstart engages and knows to boot over HTTP, its first job is to
aquire its address through DHCP. The first broadcast is never handled
and times out, thus causing a stop point for the user asking methodology
for aquiring an address.
When you select OK to try DHCP again, it aquires, and the installation
continues as it should.
I've seen this problem reported before, but never really seen an
applicable solution. In the DHCP logs I see a broadcast coming over the
lines but I don't know why its not getting a response at this time and
why it gets it on the second trial. The Console logs:
Sending DHCP request through device eth0
Waiting for link
5 seconds . . .
Pump told us: no DHCP reply recieved.
Gut check says DHCP server is being pinged too fast by an address that
was just allocated but I'm not sure where to head next.. might be way
off base but if anyone has some guesses, I'd like to hear them. Install
is 100% right on after this, but w/o this fixed I can't have a
person-less-install.
If there is no direct solution, is there a way to get it to just try
again if it fails?
Thanks,
-a
--
Andy Ciordia, Network Engineer
Planned Giving Design Center (www.pgdc.com)
10800-D Independence Pointe Pkwy, Matthews, NC 28105
Ph: (704)849-0731 x106 | Fax: (770)456-5239
--
(are you a bot that sends mal-mail? Try webfaux@xxxxxxxx its just for you!)
