On Thu, Oct 30, 2003 at 10:48:38AM -0700, Aaron M Morrison wrote: : hmmmm : I assume you want to do this w/ Software raid? : Last time I set up anything w/ software raid it DID NOT support RAID 10 : although that could have certainly changed by now. : Also, it forced you to run either raid 1 or 5 for / and /boot Yeah, as far as I could tell, there was no way, kickstart or otherwise, to install a system on to a RAID10 array. The problem is, I have two controllers with 8 120GB drives each, and the only configs that make sense are a stripe of mirrors between the two controllers (/boot would be its on RAID1 array with a small partition from the first drive on each controller) or a RAID5 of all the drives (again, /boot on its own small RAID1). The former can't be done in kickstart, although I can setup a large RAID10 data partition during the %post run. The latter is great, except with these controllers, I have a problem with corruption when the RAID5 array drops a bad drive. Short answer: no. * Philip Molter * Texas.Net Internet * http://www.texas.net/ * philip@xxxxxxxxx
