I was finally going to try to setup my network using nm in fedora 32. I figured after 10 years or so all the bits I use might finally work :-). But, I've defined a bridge with (seemingly) all the same properties as the fedora 31 bridge I created with network-scripts, yet my virtual machines using bridge networking never get an IP address, as if the router dhcp server never sees them. Is there some magic I'm missing to make things on the bridge visible on the physical network? Here's the commands I used to setup the bridge: nmcli con show nmcli con add ifname br0 type bridge con-name br0 nmcli con add type bridge-slave ifname eth0 master br0 nmcli con mod br0 ipv4.ignore-auto-dns yes nmcli con mod br0 bridge.mac-address xx:xx:... nmcli con modify br0 bridge.stp no nmcli con down "Wired connection 1" nmcli con up br0 nmcli con show The bridge gets an IP address from the router, but virtual machines do not: <interface type="bridge"> <mac address="52:54:00:1c:57:9f"/> <source bridge="br0"/> <model type="virtio"/> <address type="pci" domain="0x0000" bus="0x01" slot="0x00" function="0x0"/> </interface> _______________________________________________ users mailing list -- users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe send an email to users-leave@xxxxxxxxxxxxxxxxxxxxxxx Fedora Code of Conduct: https://docs.fedoraproject.org/en-US/project/code-of-conduct/ List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines List Archives: https://lists.fedoraproject.org/archives/list/users@xxxxxxxxxxxxxxxxxxxxxxx
