(on 02/20/2020 8:17pm mountain time, John said)
> (if using Gnome...)
> Step 1: `sudo firewall-cmd --set-default-zone=public`
-bash.16[~]: firewall-cmd --set-default-zone=public
Warning: ZONE_ALREADY_SET: public
success
-bash.17[~]
> After this, you'll want to get the name of the primary interface.
> You can do this with a few commands, I recommend `ip link`.
> It will likely begin with 'enp', for example, 'enp0s1'.
-bash.17[~]: ip link
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode
DEFAULT group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: eno1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state
UP mode DEFAULT group default qlen 1000
link/ether 30:85:a9:97:53:7e brd ff:ff:ff:ff:ff:ff
3: virbr0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc noqueue
state DOWN mode DEFAULT group default qlen 1000
link/ether 52:54:00:ca:4d:bd brd ff:ff:ff:ff:ff:ff
4: virbr0-nic: <BROADCAST,MULTICAST> mtu 1500 qdisc fq_codel master
virbr0 state DOWN mode DEFAULT group default qlen 1000
link/ether 52:54:00:ca:4d:bd brd ff:ff:ff:ff:ff:ff
-bash.18[~]: ip link | grep enp
-bash.19[~]:
Nothing starting with "enp". So what is the interface name that I
should use in the second firewall-cmd?
_______________________________________________
users mailing list -- users@xxxxxxxxxxxxxxxxxxxxxxx
To unsubscribe send an email to users-leave@xxxxxxxxxxxxxxxxxxxxxxx
Fedora Code of Conduct: https://docs.fedoraproject.org/en-US/project/code-of-conduct/
List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines
List Archives: https://lists.fedoraproject.org/archives/list/users@xxxxxxxxxxxxxxxxxxxxxxx
