On 2/19/19 12:20 PM, Howard Howell wrote:
I did a clean install of F28. Couldn't get the upgrade to work!! So I don't think it would be old extensions, but then I do a lot of development work and get loads of stuff downloaded from time to time installing the bits I need, and some of that may have imported old stuff.
Even with extensions disabled, there were still lots of stack traces. I think it's getting better in F29.
Should I add the printer using the cups 631 interface or the settings panel? The settings panel just threw me off today when I was attempting to answer your first message.
If Gnome settings is crashing your session, you should figure that out. You can add printers using the system-config-printer tool as well. That's usually what I use.
After seeing the cruft in journalctl, I did a journalctl reset and set it to just keep 2 days worth. I may want to up that later.
Unless you're running out of disk space, why limit it?
/************************* finger stuff ************************** $finger print reader daemon
You just found the "finger" command. I haven't used that since university. :-)
You can ignore the fprintd log lines. _______________________________________________ users mailing list -- users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe send an email to users-leave@xxxxxxxxxxxxxxxxxxxxxxx Fedora Code of Conduct: https://getfedora.org/code-of-conduct.html List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines List Archives: https://lists.fedoraproject.org/archives/list/users@xxxxxxxxxxxxxxxxxxxxxxx
