On 05/08/17 14:46, Doug wrote:
You must run this command as
root--probably a sudo command in your
system.
Here's how it works in my system. (Do
not input the "<<<<<") Note that it
identifies
each device by its manufacturer's
name. So when it encounters your Brother,
it should display the name and IP.
--doug
[root@linux1 doug]# nmap -sP
192.168.1.* <<<<<
Starting Nmap 7.40 ( https://nmap.org
) at 2017-05-08 14:37 EDT
Nmap scan report for 192.168.1.1
Host is up (-0.20s latency).
MAC Address: 30:5A:3A:A0:55:30
(Asustek Computer)
Nmap scan report for 192.168.1.12
Host is up (0.000052s latency).
MAC Address: 50:E5:49:B3:A2:51
(Giga-byte Technology)
Nmap scan report for 192.168.1.26
Host is up (0.00019s latency).
MAC Address: A4:EE:57:73:CB:85 (Seiko
Epson)
Nmap scan report for 192.168.1.29
Host is up (0.00013s latency).
MAC Address: D0:BF:9C:34:CF:8A
(Hewlett Packard)
Nmap scan report for 192.168.1.11
Host is up.
Nmap done: 256 IP addresses (5 hosts
up) scanned in 5.78 seconds
+
Yes this did come through and I did as
you suggested but never found the wifi
address of the printer. The wireless
functions were disabled as I suspected.
# nmap -sP 192.168.1.* is a command I
was not familiar with but will be in my
notes when next I need it.
Th hank you,
Bob
--
Bob Goodwin - Zuni, Virginia, USA
http://www.qrz.com/db/W2BOD
box10 FEDORA-25/64bit LINUX XFCE Fastmail POP3
_______________________________________________
users mailing list -- users@xxxxxxxxxxxxxxxxxxxxxxx
To unsubscribe send an email to users-leave@xxxxxxxxxxxxxxxxxxxxxxx
