On 10/06/2015 03:19 AM, Bob Goodwin wrote:
On 10/05/15 21:18, Robert Nichols wrote:
All you needed to do was add a routing table entry to direct packets for
1.1.1.1 out the appropriate interface. No need to mess up the rest of
your networking.
.
I was able to accomplish what I needed to do and the system was returned
to normal without much difficulty but I am interested in your suggestion
since this is something that comes up at times however I could use a
some clarification of:
"add a routing table entry to direct packets for
1.1.1.1 out the appropriate interface."
After a bit of Googling I see the following which seems like it might
apply to my need to access the Buffalo ethernet bridge device I needed
to access after doing a default "reset" to 1.1.1.1.
"Directly Attached Network The local network entry corresponds to the
directly attached network. IP packets destined for the directly attached
network are not forwarded to a router but sent directly to the
destination. Note that the Gateway and Interface columns match the IP
address of the node. This indicates that the packet is sent from the
network adapter corresponding to the node's IP address."
I don't know exactly how to do that, an example perhaps ...
ip route add to 1.1.1.1 dev enp0s25
That's all there is to it. Your system now knows that address 1.1.1.1
can be reached directly (no gateway) on that interface. At some point
you'll probably want to run "ip route delete 1.1.1.1", but there's no
rush unless you want to connect to a 1.1.1.1 address out there on the
internet.
--
Bob Nichols "NOSPAM" is really part of my email address.
Do NOT delete it.
--
users mailing list
users@xxxxxxxxxxxxxxxxxxxxxxx
To unsubscribe or change subscription options:
https://admin.fedoraproject.org/mailman/listinfo/users
Fedora Code of Conduct: http://fedoraproject.org/code-of-conduct
Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
Have a question? Ask away: http://ask.fedoraproject.org
