On 09/08/2014 03:33 PM, Louis Lagendijk wrote:
On Mon, 2014-09-08 at 14:02 -0400, Robert Moskowitz wrote:
I know that to support vlaning, I have a ifcfg-eth0.n file with the
entry vlan=yes and this will support vlan tag value n.
But can I leave off the default ifcfg-eth0 file and have NO untagged usage?
I know I can configure my switch to only provided tagged frames to a port.
Just define ifcfg-eth0 without IP-address but active. Then ifcfg-eth0.x
can be used for the tagged packages.
I think there has to be a bit more than that, just in case there is some
system doing DHCP or RA on the default VLAN just to make things difficult.
onboot=yes
bootproto=none
NM_CONTROLLED=no
NETWORKING=no
IPV6INIT=no
IPV6_AUTOCONF=no
And if Networking=no, is the IPV6 reduntant?
--
users mailing list
users@xxxxxxxxxxxxxxxxxxxxxxx
To unsubscribe or change subscription options:
https://admin.fedoraproject.org/mailman/listinfo/users
Fedora Code of Conduct: http://fedoraproject.org/code-of-conduct
Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
Have a question? Ask away: http://ask.fedoraproject.org
