On 12/24/2013 01:42 AM, Bill Murray issued this missive:
Dear all,
I had trouble persuading 'fedup --network 20' to run on my f19
laptop. It install all the files and gets ready. Then it boots and gets
as far as:
[ OK ] Started trigger flushing of journal to persistent storage
[ OK ] Started Forward Password Requests to Plymouth
[ OK ] Started Forward Password Requests to Plymouth
[ OK] Started Recreate Volatile files and Directories
There are then 3 lines of selinux permission denied. But no problem,
selinux is set permissive anyway.
Earlier on I see 'dracut-initqueue[400] failed to issue method call:
Access denied'
However, when I add selinux=0 to the command line..installation proceeds.
This is very odd - selinux was in permissive mode.
I've said this before and I'll say it again...permissive mode does NOT
allow ALL access (permissive != disabled, despite what others may say).
If you see selinux deny messages, it's still being denied. I've seen
this bite people a number of times.
----------------------------------------------------------------------
- Rick Stevens, Systems Engineer, AllDigital ricks@xxxxxxxxxxxxxx -
- AIM/Skype: therps2 ICQ: 22643734 Yahoo: origrps2 -
- -
- This message printed using recycled bandwidth -
----------------------------------------------------------------------
--
users mailing list
users@xxxxxxxxxxxxxxxxxxxxxxx
To unsubscribe or change subscription options:
https://admin.fedoraproject.org/mailman/listinfo/users
Fedora Code of Conduct: http://fedoraproject.org/code-of-conduct
Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
Have a question? Ask away: http://ask.fedoraproject.org
