On 10/14/2013 09:57 AM, antonio issued this missive:
Rick Stevens ha scritto / said the following il giorno/on 14/10/2013
18:31:
On 10/12/2013 02:02 PM, antonio montagnani issued this missive:
we are testing a 3D printer, with Marlin driver.With Repitiert Host at
first test we didn't get any connection with 250000 baud rate.From
googling around I am confused if 250000 baud can be accepted by Fedora
(I think so)
Printer works fine in Windows with same baud rate.Are we missing some
point??
Printer is 3drag from an Italian company, Futura Elettronica
I've never heard of a 250K baud rate. I have seen 230.4K (230400) and
256K (256000). I suppose it's possible but I don't know if a standard
program (e.g. stty) would know how to set those. It's dependent on the
crystal frequency being fed to the USART along with the various divisors
in the USART's registers.
It may be that the Windows program goes down into the hardware more
deeply than standard Linux software does. You could probably do it
by writing code that pokes the appropriate registers in the USART but
I wouldn't know how to go about it. It's been a while since I did any
bit-fiddling at that level.
----------------------------------------------------------------------
- Rick Stevens, Systems Engineer, AllDigital ricks@xxxxxxxxxxxxxx -
- AIM/Skype: therps2 ICQ: 22643734 Yahoo: origrps2 -
- -
- Hard work has a future payoff. Laziness pays off now. -
----------------------------------------------------------------------
tnx Rick foryour reply.
I confirm that speed is 250000 baud and with same speed it works great
in Linux if I use Cura.
Great! You're a smarter man than I, Antonio. As I said, that's just an
unfamiliar baud rate to me. Glad you got it sorted out.
----------------------------------------------------------------------
- Rick Stevens, Systems Engineer, AllDigital ricks@xxxxxxxxxxxxxx -
- AIM/Skype: therps2 ICQ: 22643734 Yahoo: origrps2 -
- -
- Politicians are the opposite of pickpockets because you never see -
- them take their hand out of your pocket. -
- -- Larry Fine -
----------------------------------------------------------------------
--
users mailing list
users@xxxxxxxxxxxxxxxxxxxxxxx
To unsubscribe or change subscription options:
https://admin.fedoraproject.org/mailman/listinfo/users
Fedora Code of Conduct: http://fedoraproject.org/code-of-conduct
Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
Have a question? Ask away: http://ask.fedoraproject.org
