Thank, Here it is The camera says connexion to PC in progress, and it takes a very long time before it disappears. In addition, if I try to add the camera manually from digikam, there is not model showing up. It looks like that I need to install some drivers. Aug 1 01:00:02 sophocle systemd-udevd[11100]: inotify_add_watch(7, /dev/sdb, 10) failed: No such file or directory Aug 1 01:00:07 sophocle kernel: [11896.611096] usb 1-6: new high-speed USB device number 7 using ehci-pci Aug 1 01:00:07 sophocle kernel: [11896.728118] usb 1-6: New USB device found, idVendor=04da, idProduct=2372 Aug 1 01:00:07 sophocle kernel: [11896.728127] usb 1-6: New USB device strings: Mfr=1, Product=2, SerialNumber=3 Aug 1 01:00:07 sophocle kernel: [11896.728131] usb 1-6: Product: DMC-TZ18 Aug 1 01:00:07 sophocle kernel: [11896.728135] usb 1-6: Manufacturer: Panasonic Aug 1 01:00:07 sophocle kernel: [11896.728138] usb 1-6: SerialNumber: 0000000000000000006F1302150801 Aug 1 01:00:07 sophocle kernel: [11896.728801] usb-storage 1-6:1.0: USB Mass Storage device detected Aug 1 01:00:07 sophocle kernel: [11896.733248] usb-storage 1-6:1.0: Quirks match for vid 04da pid 2372: 90 Aug 1 01:00:07 sophocle kernel: [11896.735270] scsi5 : usb-storage 1-6:1.0 Aug 1 01:00:07 sophocle mtp-probe: checking bus 1, device 7: "/sys/devices/pci0000:00/0000:00:1d.7/usb1/1-6" Aug 1 01:00:07 sophocle mtp-probe: bus: 1, device: 7 was not an MTP device Aug 1 01:00:08 sophocle kernel: [11897.738193] scsi 5:0:0:0: Direct-Access MATSHITA DMC-TZ18 0110 PQ: 0 ANSI: 2 Aug 1 01:00:08 sophocle kernel: [11897.738800] sd 5:0:0:0: Attached scsi generic sg2 type 0 Aug 1 01:00:08 sophocle kernel: [11897.740008] sd 5:0:0:0: [sdb] Adjusting the sector count from its reported value: 15523840 Aug 1 01:00:08 sophocle kernel: [11897.740054] sd 5:0:0:0: [sdb] 15523839 512-byte logical blocks: (7.94 GB/7.40 GiB) Aug 1 01:00:08 sophocle kernel: [11897.741035] sd 5:0:0:0: [sdb] Write Protect is on Aug 1 01:00:08 sophocle kernel: [11897.741890] sd 5:0:0:0: [sdb] No Caching mode page present Aug 1 01:00:08 sophocle kernel: [11897.741898] sd 5:0:0:0: [sdb] Assuming drive cache: write through Aug 1 01:00:38 sophocle kernel: [11928.101092] usb 1-6: reset high-speed USB device number 7 using ehci-pci Aug 1 01:01:09 sophocle kernel: [11959.109182] usb 1-6: reset high-speed USB device number 7 using ehci-pci Aug 1 01:01:41 sophocle kernel: [11990.213151] usb 1-6: reset high-speed USB device number 7 using ehci-pci Aug 1 01:02:11 sophocle kernel: [12021.189094] usb 1-6: reset high-speed USB device number 7 using ehci-pci Aug 1 01:02:12 sophocle kernel: [12021.312222] sd 5:0:0:0: [sdb] Adjusting the sector count from its reported value: 15523840 Aug 1 01:02:12 sophocle kernel: [12021.313518] sd 5:0:0:0: [sdb] No Caching mode page present Aug 1 01:02:12 sophocle kernel: [12021.313525] sd 5:0:0:0: [sdb] Assuming drive cache: write through Aug 1 01:02:42 sophocle kernel: [12052.165207] usb 1-6: reset high-speed USB device number 7 using ehci-pci Aug 1 01:03:13 sophocle kernel: [12083.141074] usb 1-6: reset high-speed USB device number 7 using ehci-pci Aug 1 01:03:44 sophocle kernel: [12114.117204] usb 1-6: reset high-speed USB device number 7 using ehci-pci Aug 1 01:04:15 sophocle kernel: [12145.157208] usb 1-6: reset high-speed USB device number 7 using ehci-pci > ----- Original Message ----- > From: Ed Greshko > Sent: 08/01/13 01:02 AM > To: Community support for Fedora users > Subject: Re: Camera panasonic-TZ18 > > On 08/01/13 06:55, Patrick Dupre wrote: > > I connected my camera panasonic DMC-TZ18 > > Bus 001 Device 005: ID 04da:2372 Panasonic (Matsushita) Lumix Camera (Storage mode) > > > > but it does not seem to be seen by the computer. > > no camera been by digicam or shotwell. > > Do I need to install some drivers? > > Watch /var/log/messages as you plug it in. Sounds as if it may be to be accessed as a USB drive. > > -- > Getting tired of non-Fedora discussions and self-serving posts > -- > users mailing list > users@xxxxxxxxxxxxxxxxxxxxxxx > To unsubscribe or change subscription options: > https://admin.fedoraproject.org/mailman/listinfo/users > Fedora Code of Conduct: http://fedoraproject.org/code-of-conduct > Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines > Have a question? Ask away: http://ask.fedoraproject.org =========================================================================== Patrick DUPRÉ | | email: pdupre@xxxxxxx Laboratoire de Physico-Chimie de l'Atmosphère | | Université du Littoral-Côte d'Opale | | Tel. (33)-(0)3 28 23 76 12 | | Fax: 03 28 65 82 44 189A, avenue Maurice Schumann | | 59140 Dunkerque, France =========================================================================== -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Fedora Code of Conduct: http://fedoraproject.org/code-of-conduct Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines Have a question? Ask away: http://ask.fedoraproject.org
