Am 22.03.2013 21:32, schrieb poma: > On 22.03.2013 13:00, Harald Hoyer wrote: > ... >> you must not resume from a raid array >> > > Let me show you how country feels :) > > Version: 025-35.git20130211.fc18 [1] > > /etc/dracut.conf.d/dracut-custom.conf: > # Custom dracut config file > > # /etc/dracut.conf.d/*.conf will override the settings in /etc/dracut.conf > > # build initrd only to boot current hardware > hostonly="yes" > > # Bring up <device> in initramfs, <device> should be the device name. > # Beside device name, it would be nice if one can use fstab alike UUID. > # This can be useful in hostonly mode for resume support when > # your swap is on LVM an encrypted partition or on a MD RAID partition. > add_device+=" /dev/md1 " > .. > > The corresponding command: > dracut --hostonly --device /dev/md1 [-f] [-v] > .. > > PM: Hibernation image not present or could not be loaded. > PM: Hibernation mode set to 'platform' > PM: Marking nosave pages: [mem 0x0009e000-0x000fffff] > PM: Marking nosave pages: [mem 0xcfef0000-0xffffffff] > PM: Marking nosave pages: [mem 0xc4000000-0xc7ffffff] > PM: Basic memory bitmaps created > PM: Syncing filesystems ... done. > PM: Preallocating image memory... done (allocated 279164 pages) > PM: Allocated 1116656 kbytes in 0.30 seconds (3722.18 MB/s) > PM: freeze of devices complete after 1463.281 msecs > PM: late freeze of devices complete after 0.472 msecs > PM: noirq freeze of devices complete after 0.354 msecs > PM: Saving platform NVS memory > PM: Creating hibernation image: > PM: Need to copy 292982 pages > PM: Normal pages needed: 292982 + 1024, available pages: 738735 > PM: Restoring platform NVS memory > PM: noirq restore of devices complete after 21.957 msecs > PM: early restore of devices complete after 0.352 msecs > PM: restore of devices complete after 1290.944 msecs > PM: Image restored successfully. > PM: Basic memory bitmaps freed > .. > > Swap redundancy is good, right? ;) > > poma > Sure, if it works for you :) One recommendation: please use UUID= instead of relying on the kernel numbering scheme for devices, if you want to avoid problems. -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines Have a question? Ask away: http://ask.fedoraproject.org
