On Sun, 2012-03-04 at 15:57 -0600, Aaron Konstam wrote: > Well your point is incorrect. Cups browsing did not work if UTC was > not set. TThe clocks were set correctly. The hardware clock was > operating on UTC time and the system clock was running on local time. You just don't get it, do you?! You've even said it above: Your hardware clock is running on UTC Therefore, you ***MUST*** set your clock configuration to say that UTC is set. If you do not, then your time is set wrong. Correct setting of your time is dependent on the hardware clock, setting the UTC/not-UTC flag, and setting the correct timezone. The combination of them all allows the computer to work out what localtime is. Again, I repeat, it's not a CUPS fault that it doesn't like UTC set. It's your fault that you're running your clock on UTC but saying that it is not. The UTC/not-UTC setting is for the hardware clock, not the software clock. If you run the hardware clock on UTC, then you set the UTC flag for UTC. If you run the hardware clock on local time, then set the UTC flag for local time. CUPS will work either way. It doesn't care whether one clock is set to UTC, or not. What it cares about is the correct time. But if you set your hardware clock on UTC, but say it's running localtime; or, if you set your clock on localtime, but say it's running on UTC; you ARE going to have problems, because doing so is just plain wrong. *** THE UTC FLAG IS FOR THE HARDWARE CLOCK *** ^^^^^^^^ I've said this about three times, in three emails, what's so hard to understand about it? -- [tim@localhost ~]$ uname -r 2.6.27.25-78.2.56.fc9.i686 Don't send private replies to my address, the mailbox is ignored. I read messages from the public lists. -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines Have a question? Ask away: http://ask.fedoraproject.org