On 09/30/2011 11:37 AM, Kevin H. Hobbs wrote: > I have a fedora 14 server here who's ethernet interface seems to take > just a bit too long to establish a link. > > Whenever it starts it is inaccessible over the network, which is a real > pain for a server. I have to go over with the monitor and keyboard, > crawl under the desk... > > When I try to restart the network interface with "service network > restart" I get something that looks like : > > Bringing up interface eth0: > Determining IP information for eth0...[big number] ADDRCONF(NETDEV_UP): > eth0: link is not ready..... > [FAILED] > [big number] e1000e: eth0 NIC Link is Up 1000 Mbps Full Duplex... > > Which sounds to me like a timeout was just a bit too short. > > If I try a few times in a row suddenly it works. > > [kevin@backup ~]$ uname -a > Linux backup.hooperlab 2.6.35.14-96.fc14.x86_64 #1 SMP Thu Sep 1 > 11:59:56 UTC 2011 x86_64 x86_64 x86_64 GNU/Linux > > [kevin@backup ~]$ lspci -nn | grep -i eth > 04:00.0 Ethernet controller [0200]: Intel Corporation 82573E Gigabit > Ethernet Controller (Copper) [8086:108c] (rev 03) > 05:05.0 Ethernet controller [0200]: Intel Corporation 82541GI Gigabit > Ethernet Controller [8086:1076] (rev 05) > > [kevin@backup ~]$ dmesg | tail > [ 1633.233297] e1000e 0000:04:00.0: irq 73 for MSI/MSI-X > [ 1633.284094] e1000e 0000:04:00.0: irq 73 for MSI/MSI-X > [ 1633.285079] ADDRCONF(NETDEV_UP): eth0: link is not ready > [ 1642.265283] e1000e 0000:04:00.0: irq 73 for MSI/MSI-X > [ 1642.316094] e1000e 0000:04:00.0: irq 73 for MSI/MSI-X > [ 1642.317556] ADDRCONF(NETDEV_UP): eth0: link is not ready > [ 1647.280547] e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow > Control: RX/TX > [ 1647.285563] e1000e 0000:04:00.0: eth0: 10/100 speed: disabling TSO > [ 1647.291153] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready > [ 1657.802008] eth0: no IPv6 routers present Sounds like the switch it's connected to is having issues with the autonegotiation for speed or duplex settings. That's not that uncommon with certain switches. You might try adding the appropriate parameters to your /etc/modprobe.d/dist.conf: options e1000 speed=100 duplex=full to remove the autonegotiation from the mix. ---------------------------------------------------------------------- - Rick Stevens, Systems Engineer, C2 Hosting ricks@xxxxxxxx - - AIM/Skype: therps2 ICQ: 22643734 Yahoo: origrps2 - - - - Careful! Ugly strikes 9 out of 10 people! - ---------------------------------------------------------------------- -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
