Re: intel 5100 wifi card problem

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 06/28/2011 01:39 PM, Hüvely Balázs wrote:
> Hi All!
>
> I have a big and old problem with my toshiba satellite notebook's wifi.
> The original wifi card was a realtek, which is always freezed, so after
> a few months I decided to replace that card to an intel one. I searched
> the net for full supported wifi card, and I found that intel wifi link
> 5100 will be the good choice for linux.
>
> I get the interface, installed to my computer, and everything was fine
> for a little time.
>
> Now my problem is the card after few minutues or an hour hangs on. I
> tried to associate the card again to my AP, but no success. I look after
> for my dmesg, and here below my results:
>
> [  120.302525] iwlagn 0000:06:00.0: Aggregation not enabled for tid 0
> because load = 0
> [  123.115878] process `skype' is using obsolete setsockopt SO_BSDCOMPAT
> [  123.542529] iwlagn 0000:06:00.0: iwlagn_tx_agg_start on ra =
> 74:ea:3a:a5:d3:28 tid = 0
> [  183.974273] SELinux: initialized (dev proc, type proc), uses
> genfs_contexts
> [  400.474353] TCP lp registered
> [ 1723.179600] iwlagn 0000:06:00.0: Error sending REPLY_ADD_STA: time
> out after 500ms.
> [ 1723.179611] HW problem - can not stop rx aggregation for tid 0
> [ 1723.679449] iwlagn 0000:06:00.0: Error sending REPLY_ADD_STA: time
> out after 500ms.
> [ 1723.679458] HW problem - can not stop rx aggregation for tid 6
> [ 1724.179220] iwlagn 0000:06:00.0: Error sending REPLY_QOS_PARAM: time
> out after 500ms.
> [ 1724.179230] iwlagn 0000:06:00.0: Failed to update QoS
> [ 1724.678972] iwlagn 0000:06:00.0: Error sending REPLY_RXON: time out
> after 500ms.
> [ 1724.678984] iwlagn 0000:06:00.0: Error clearing ASSOC_MSK on BSS (-110)
> [ 1725.178850] iwlagn 0000:06:00.0: Error sending REPLY_RXON: time out
> after 500ms.
> [ 1725.178860] iwlagn 0000:06:00.0: Error clearing ASSOC_MSK on BSS (-110)
> [ 1725.678547] iwlagn 0000:06:00.0: Error sending REPLY_QOS_PARAM: time
> out after 500ms.
> [ 1725.678561] iwlagn 0000:06:00.0: Failed to update QoS
> [ 1726.178336] iwlagn 0000:06:00.0: Error sending REPLY_RXON: time out
> after 500ms.
> [ 1726.178348] iwlagn 0000:06:00.0: Error clearing ASSOC_MSK on BSS (-110)
> [ 1726.178369] iwlagn 0000:06:00.0: Stopping AGG while state not ON or
> starting
> [ 1726.680114] iwlagn 0000:06:00.0: Error sending REPLY_ADD_STA: time
> out after 500ms.
> [ 1726.680137] ieee80211 phy0: failed to remove key (0,
> 74:ea:3a:a5:d3:28) from hardware (-110)
> [ 1727.179980] iwlagn 0000:06:00.0: Error sending REPLY_REMOVE_STA: time
> out after 500ms.
> [ 1727.179988] iwlagn 0000:06:00.0: Error removing station
> 74:ea:3a:a5:d3:28
> [ 1727.679730] iwlagn 0000:06:00.0: Error sending REPLY_RXON: time out
> after 500ms.
> [ 1727.679740] iwlagn 0000:06:00.0: Error clearing ASSOC_MSK on BSS (-110)
> [ 1729.680851] iwlagn 0000:06:00.0: fail to flush all tx fifo queues
> [ 1730.180672] iwlagn 0000:06:00.0: Error sending REPLY_RXON: time out
> after 500ms.
> [ 1730.180687] iwlagn 0000:06:00.0: Error clearing ASSOC_MSK on BSS (-110)
> [ 1730.686517] iwlagn 0000:06:00.0: Error sending REPLY_ADD_STA: time
> out after 500ms.
> [ 1730.686533] ieee80211 phy0: failed to remove key (1,
> ff:ff:ff:ff:ff:ff) from hardware (-110)
> [ 1730.686660] cfg80211: Calling CRDA to update world regulatory domain
> [ 1731.187203] iwlagn 0000:06:00.0: Error sending REPLY_RXON: time out
> after 500ms.
> [ 1731.187211] iwlagn 0000:06:00.0: Error clearing ASSOC_MSK on BSS (-110)
> [ 1731.627020] iwlagn 0000:06:00.0: Queue 4 stuck for 10000 ms.
> [ 1731.627032] iwlagn 0000:06:00.0: On demand firmware reload
> [ 1731.687024] iwlagn 0000:06:00.0: Error sending REPLY_RXON: time out
> after 500ms.
> [ 1731.687037] iwlagn 0000:06:00.0: Error clearing ASSOC_MSK on BSS (-110)
> [ 1731.687059] iwlagn 0000:06:00.0: Request scan called when driver not
> ready.
> [ 1731.687325] cfg80211: World regulatory domain updated:
> [ 1731.687331] cfg80211:     (start_freq - end_freq @ bandwidth),
> (max_antenna_gain, max_eirp)
> [ 1731.687337] cfg80211:     (2402000 KHz - 2472000 KHz @ 40000 KHz),
> (300 mBi, 2000 mBm)
> [ 1731.687343] cfg80211:     (2457000 KHz - 2482000 KHz @ 20000 KHz),
> (300 mBi, 2000 mBm)
> [ 1731.687348] cfg80211:     (2474000 KHz - 2494000 KHz @ 20000 KHz),
> (300 mBi, 2000 mBm)
> [ 1731.687354] cfg80211:     (5170000 KHz - 5250000 KHz @ 40000 KHz),
> (300 mBi, 2000 mBm)
> [ 1731.687359] cfg80211:     (5735000 KHz - 5835000 KHz @ 40000 KHz),
> (300 mBi, 2000 mBm)
> [ 1731.687707] cfg80211: Calling CRDA for country: HU
> [ 1731.706420] iwlagn 0000:06:00.0: MAC is in deep sleep!.  CSR_GP_CNTRL
> = 0xFFFFFFFF
> [ 1731.720236] cfg80211: Regulatory domain changed to country: HU
> [ 1731.720240] cfg80211:     (start_freq - end_freq @ bandwidth),
> (max_antenna_gain, max_eirp)
> [ 1731.720243] cfg80211:     (2402000 KHz - 2482000 KHz @ 40000 KHz),
> (N/A, 2000 mBm)
> [ 1731.720246] cfg80211:     (5170000 KHz - 5250000 KHz @ 40000 KHz),
> (N/A, 2000 mBm)
> [ 1731.720248] cfg80211:     (5250000 KHz - 5330000 KHz @ 40000 KHz),
> (N/A, 2000 mBm)
> [ 1731.720251] cfg80211:     (5490000 KHz - 5710000 KHz @ 40000 KHz),
> (N/A, 2700 mBm)
> [ 1731.725271] iwlagn 0000:06:00.0: MAC is in deep sleep!.  CSR_GP_CNTRL
> = 0xFFFFFFFF
> [ 1731.744111] iwlagn 0000:06:00.0: MAC is in deep sleep!.  CSR_GP_CNTRL
> = 0xFFFFFFFF
> [ 1731.762903] iwlagn 0000:06:00.0: MAC is in deep sleep!.  CSR_GP_CNTRL
> = 0xFFFFFFFF
> [ 1731.781597] iwlagn 0000:06:00.0: MAC is in deep sleep!.  CSR_GP_CNTRL
> = 0xFFFFFFFF
> [ 1731.800298] iwlagn 0000:06:00.0: MAC is in deep sleep!.  CSR_GP_CNTRL
> = 0xFFFFFFFF
> [ 1731.818996] iwlagn 0000:06:00.0: MAC is in deep sleep!.  CSR_GP_CNTRL
> = 0xFFFFFFFF
> [ 1731.837699] iwlagn 0000:06:00.0: MAC is in deep sleep!.  CSR_GP_CNTRL
> = 0xFFFFFFFF
> .
> .
> .
> .
> And many MAC is in deep sleep message.
>
> Is there any workaround or fix for my card?
>
> Additional info, my card is placed my notebook sorrounded by pastic
> parts, and there is no possibility to cool down the interface. Maybe
> it's overheated.
>
> Any suggestion? How I will able to use this card normally?
>
> Thanks: Balazs problem with ath9k driver (

Does it associate if you reboot?

-- 
users mailing list
users@xxxxxxxxxxxxxxxxxxxxxxx
To unsubscribe or change subscription options:
https://admin.fedoraproject.org/mailman/listinfo/users
Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines


[Index of Archives]     [Older Fedora Users]     [Fedora Announce]     [Fedora Package Announce]     [EPEL Announce]     [EPEL Devel]     [Fedora Magazine]     [Fedora Summer Coding]     [Fedora Laptop]     [Fedora Cloud]     [Fedora Advisory Board]     [Fedora Education]     [Fedora Security]     [Fedora Scitech]     [Fedora Robotics]     [Fedora Infrastructure]     [Fedora Websites]     [Anaconda Devel]     [Fedora Devel Java]     [Fedora Desktop]     [Fedora Fonts]     [Fedora Marketing]     [Fedora Management Tools]     [Fedora Mentors]     [Fedora Package Review]     [Fedora R Devel]     [Fedora PHP Devel]     [Kickstart]     [Fedora Music]     [Fedora Packaging]     [Fedora SELinux]     [Fedora Legal]     [Fedora Kernel]     [Fedora OCaml]     [Coolkey]     [Virtualization Tools]     [ET Management Tools]     [Yum Users]     [Yosemite News]     [Gnome Users]     [KDE Users]     [Fedora Art]     [Fedora Docs]     [Fedora Sparc]     [Libvirt Users]     [Fedora ARM]

  Powered by Linux