I followed the advice here: http://wiki.libvirt.org/page/Networking#Bridged_networking_.28aka_.22shared_physical_device.22.29 Working, but one thing strange. My enet I/F on the host used to be eth1. Now it says it's the bridge br0. Is this as expected? br0 Link encap:Ethernet HWaddr 00:E0:81:B1:49:F8 inet addr:10.32.111.113 Bcast:255.255.255.255 Mask:255.255.255.0 inet6 addr: fe80::2e0:81ff:feb1:49f8/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:1665233 errors:0 dropped:0 overruns:0 frame:0 TX packets:2446635 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:173668560 (165.6 MiB) TX bytes:2928481244 (2.7 GiB) eth1 Link encap:Ethernet HWaddr 00:E0:81:B1:49:F8 inet6 addr: fe80::2e0:81ff:feb1:49f8/64 Scope:Link UP BROADCAST RUNNING PROMISC MULTICAST MTU:1500 Metric:1 RX packets:5073158 errors:0 dropped:0 overruns:0 frame:0 TX packets:5066467 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:3649574236 (3.3 GiB) TX bytes:5083712432 (4.7 GiB) Interrupt:17 Memory:fdee0000-fdf00000 Setup: cat /etc/sysconfig/network-scripts/ifcfg-eth1 # Intel Corporation 82573V Gigabit Ethernet Controller (Copper) DEVICE=eth1 HWADDR=00:e0:81:b1:49:f8 ONBOOT=yes DHCP_HOSTNAME=nbecker6 BOOTPROTO=dhcp TYPE=Ethernet USERCTL=no PEERDNS=yes IPV6INIT=no NM_CONTROLLED=no BRIDGE=br0 cat /etc/sysconfig/network-scripts/ifcfg-br0 DEVICE=br0 TYPE=Bridge BOOTPROTO=dhcp ONBOOT=yes DELAY=0 NM_CONTROLLED=no DHCP_HOSTNAME=nbecker6 STP=on -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
