On Thu, Oct 21, 2010 at 9:56 AM, Henrik Frisk <frisk.h@xxxxxxxxx> wrote: > > > On Wed, Oct 20, 2010 at 8:06 PM, TortuXm++ <tortuxm@xxxxxxxxxx> wrote: >> >> > Hmm, I'm still getting the same results. I followed the instructions above >> > but when I reboot, after the three blue bars have finished loading and >> > turned white, the bar starts flickering and eventually comes to a halt. >> > After that nothing happens. I go back to nouveau things work fine again. Any >> > further suggestions? >> >> To help you further, what is needed is the content of your xorg log >> file. To do that you just have to wait the flickering to stop, then to >> log in as a user, copy the /var/log/Xorg.0.log somewhere you can find >> it later. >> > Towards the end these errors are printed: > > [ 47.415] (II) NVIDIA(0): Support for GLX with the Damage and Composite X extensions is > [ 47.415] (II) NVIDIA(0): enabled. > [ 47.647] (EE) NVIDIA(0): Failed to initialize the NVIDIA graphics device PCI:2:0:0. > [ 47.647] (EE) NVIDIA(0): Please check your system's kernel log for additional error > [ 47.648] (EE) NVIDIA(0): messages and refer to Chapter 8: Common Problems in the > [ 47.648] (EE) NVIDIA(0): README for additional information. > [ 47.648] (EE) NVIDIA(0): Failed to initialize the NVIDIA graphics device! > [ 47.648] (II) UnloadModule: "nvidia" > [ 47.648] (II) UnloadModule: "wfb" > [ 47.648] (II) UnloadModule: "fb" > [ 47.648] (EE) Screen(s) found, but none have a usable configuration. > [ 47.648] > Fatal server error: > [ 47.648] no screens found > [ 47.648] > > I haven't checked my kernel log though (not yet). > >> Maybe you will find the answer in the file. If you don't, you could >> post relevant errors. You should also look for errors in >> your /etc/X11/xorg.conf file, which is needed in order to tell Xorg to >> use nvidia (although it should be generated by the kmod-nvidia package) >> > This is the xorg.conf: > > # Xorg configuration created by livna-config-display > > Section "Files" > ModulePath "/usr/lib/xorg/modules" > EndSection > > Section "ServerFlags" > Option "AIGLX" "on" > EndSection > > Section "Device" > Identifier "Videocard0" > Driver "nouveau" > EndSection > > Section "Extensions" > Option "Composite" "Enable" > EndSection > >> One thing to try before logging out is to do >> >> lsmod | grep nouveau >> > As I can't log in with nvidia drivers present I can't check this. I logged in without X and the command above didn't return anythin, but I suspect no videodriver are loaded when you boot without X? > >> >> to see if nouveau has been properly blacklisted. To use the nvidia >> proprietary driver, you really need the nouveau module not to be in use. >> >> If the nouveau driver is still loaded, this means it was either not >> properly blacklisted, or you didn't run the initrd you re-created. >> >> By the way, there is probably a list for rpmfusion users, where you >> could find more information. >> > OK, thanks, I will look there too. > > best, > > /Henrik For a solution see the "Video drivers on a MacBook Pro 5,2" thread. /h -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
